Providing solutions to the woodworking industry  

 




 

Used 2005 Cehisa Rapid Series Edgebander
Model PRO-7

This machine is equipped with 2 stations: End Trim and TopBottom Trimming
  • Large coil table for roll material
  • Automatic roll cutter & strip feed magazine
  • Quick changeover for rolls or strip material
  • Standard guillotine for cutting up to 1.2mm PVC from the coil
  • Quick melt glue pot with quick change disconnect for ease of maintenance or glue color change if required.10 - 15 minutes heat-up time (depending upon voltage)
  • Digital thermostat with approaching temperature control PDI and auto temperature drop
  • Control panel located on in-feed end of machine for easy access
  • Pressure station with one motorized pressure roller plus 1 additional pressure roller
  • End trim station, single motor with double blade motor
  • Top & bottom trim station equipped with digital and carbide bevel tooling
  • Digital on top of pressure beam for height indication
  • Digital on pressure station
  • Digitals on top & bottom trim station
  • Fixed speed at 33 feet per minute
  • 220 volt / 3 phase (+/- 5%, depending on voltage)


 
Technical Specifications
Coil Cutoff maximum 1.2 mm PVC
Edgeband thickness max 1.5 mm
Panel length min 5" (120 mm)
Panel width min 3" (75 mm)
Panel thickness min 3/8 (8 mm)
Panel width max 2" (50 mm)
Feed speed 33 fpm
Feed motor 1 hp / .75 kw
Pressure section 1 motorized roller w/ 1 additional roller
End trim unit — two motors 1/3 hp / .27 kw
Tooling speed 12,000 rpm
Straight cut max 3/16" X 2 1/4"
Top & bottom trim station 1/3 hp / .27 kw
Total power required (amps) 19 amps @ 230 volt, 3 phase
Machine length 7� �" (2280 mm)
Machine width 56" � 80" depending on outrigger position
Working height 32�"
Total height 50�" (1280 mm)
Machine weight 1,244 lbs

HOLZ-HER... 1436 SEL Primus
YR 1999, 220 3 phase                

Max 3/8� solid wood banding & 3mm Pvc capacity 1/4"- 1 �� max panel thickness and 5 �� min. panel length.

Equipped with: Cartridge glue system with hopper feed & quick melt feature, Automatic magazine coil, strip & solid edge banding; Heavy duty guillotine for 3mm PVC. Pressure section with (1) large driven and two smaller idler rollers.

Work Stations: (1976)Double motor end trim (0.3hp-9000rpm HF Motors) adjustable 0-15 degrees for chamfer cuts controlled from controller. �1942� top & bottom flush trim unit (1hp-18000rpm HF- Motors) Siko digital readout. �1942M top & Bottom fine & Radius trim unit (1hp-18000rpm HF Motors) bevels 0-15 degrees Siko digital readout. 3MM Scrape station. �1944� top and bottom jump buffing.

Two feed speeds, complete with microprocessor for glue startup & stop. �PCS� pneumatic change over system for end trim, top and bottom radius & scraper from control panel: 4KVA frequency changer, outboard panel support and sound enclosure.